| Reference
|
Synopsis
|
Last Modified Date
|
| 2304383.1 |
OBP Variables are stored in the ILOM's LDom Configuration |
2017-09-05
|
| 2234201.1 |
DISK-8000-ES - A non-recoverable hardware failure was detected by the device while performing a command |
2018-03-27
|
| 2063729.1 |
FMD-8000-ET - the link between the Service Processor and host has a heartbeat failure |
2018-05-14
|
| 2028263.1 |
FMD-8000-CV - A FRU Has Been Removed |
2018-05-07
|
| 2028260.1 |
FMD-8000-A0 - A FRU Has Been Added |
2018-05-07
|
| 1929967.1 |
ILOM based SPARC Server's Solaris Clock Initialization During Boot |
2018-05-01
|
| 1923174.1 |
Oracle Optimized Solution for JD Edwards EnterpriseOne |
2014-12-12
|
| 1907465.1 |
SPARC LDOM CLI Cheat Sheet |
2017-12-15
|
| 1676591.1 |
Power source recommendations for Oracle T5xx0, T3-x, T4-x, T5-x, T7-x, S7-x, M7-x, T8-x, & M8-x servers |
2018-02-14
|
| 1665925.1 |
SysFW 8.4.2.c (or greater) and Solaris 11 SRU17.4 are required to support Oracle Virtual Machine (OVM) 3.1.1 on SPARC T4-x & Netra T4-1 Platforms |
2017-11-14
|
| 1626698.1 |
SPARC or Netra T3-x, T4-x, T5-x, Tx000, T5xx0, SB6000, T63x0, Netra CTxx - Customer Actions: Commands to run |
2017-10-11
|
| 1626676.1 |
SPARC or Netra T3-x, T4-x, T5-x, Tx000, T5xx0, SB6000, T63x0, Netra CTxx - Customer Actions: Platform Down |
2017-08-07
|
| 1626211.1 |
SPARC or Netra T3-x, T4-x, T5-x, Tx000, T5xx0, SB6000, T63x0, Netra CTxx - Customer Actions: No action |
2017-09-13
|
| 1609147.1 |
How to recover from lost ILOM 3.0 password on T3/T4/T5/T7, T5x20, T5x40 Servers |
2017-11-14
|
| 1600500.1 |
DIMM Configuration Rules For T3-1b, T3-1, T3-2, T3-4, T4-1b, T4-1, T4-2, T4-4, T5-1b, T5-2, T5-4, T5-8, T7-1, T7-2, T7-4, S7-2, S7-2L, T8-1, T8-2, T8-4 Servers and Blades |
2017-11-29
|
| 1597723.1 |
T3 and T4 System On Board and REM LSI Controller Firmware Upgrade |
2017-05-24
|
| 1571054.1 |
Performing an AC power cycle on the T3/T4/T5/S7/T7/T8 Servers |
2017-11-15
|
| 1569517.1 |
SPARC T3/T4 : MegaCLI : How to Convert the RAID Level of a Virtual Drive (LUN) On-line |
2017-09-29
|
| 1569250.1 |
SPARC T3/T4 : MegaCLI exit codes and what they mean |
2018-03-30
|
| 1553399.1 |
Collecting snapshot via the GUI on ILOM 3.x and later platforms |
2018-01-09
|
| 1541150.1 |
How to reset the SP on a T3-x T4-x T5-x T7-x S7-x |
2018-01-05
|
| 1506246.1 |
Creating the boot path on SPARC T3 - T8 Servers for internal disks |
2018-03-28
|
| 1494121.1 |
New 16 GB and 32 GB DIMMs Supported in the T4 Systems |
2017-05-24
|
| 1483194.1 |
Commands to run to fully clear ILOM/SP, faultmgmt shell, and FMA faults on the T3-x, T4-x , T5-x Servers |
2017-12-22
|
| 1470580.1 |
Troubleshooting data needed for T3-x, T4-x, T5-x, T7-x, S7-x, T8-x servers |
2018-03-06
|
| 1454231.1 |
Niwot SAS cable pinout differs from system board SAS cable |
2017-05-23
|
| 1453086.1 |
Firmware containing Hypervisor on CMT servers with an ILOM reserve memory during boot |
2018-01-22
|
| 1399079.1 |
Repair of ILOM error: "Warning: The system appears to be in manufacturing test mode." |
2017-09-28
|
| 1390261.1 |
SPARC T3 and T4 Platforms may see Dropped or Double Character Input from USB Keyboards |
2017-11-15
|
| 1387771.1 |
Troubleshooting inability to see a pre-existing RAID volume on T3, T4, T5, T7 & T8 systems |
2017-11-02
|
| 1377899.1 |
How to Setup rKVMS on SPARC T3-1 / T4-1 |
2017-11-15
|
| 1367602.1 |
T3/4/5/7 series system usage of internal RAID with sas2ircu & sas3ircu |
2017-05-01
|
| 1367079.1 |
Data to collect to isolate most T3 & T4 series system problems |
2018-02-28
|
| 1021607.1 |
ZFS-8000-8A - A file or directory could not be read due to corrupt data |
2018-03-27
|
| 1021194.1 |
PCI-8000-7J - PCI subsystem problem |
2018-05-15
|
| 1021161.1 |
NXGE-8000-0U - NXGE XFP Optical Transceiver Fault |
2017-05-13
|
