Problem Document
|
Synopsis
|
Last Modified Date
|
2125157.1 |
isp driver messages that may indicate an HBA hardware failure: WARNING: Chip reset timeout - reset/init ISP chip failed - couldn't load firmware - Unable to attach: check for hardware problem - ISP: Firmware cmd timeout |
2018-02-28
|
2077573.1 |
Sun Fire[TM] 3800, 4800, 4810, 6800, E4900, E6900: Platform.SC: ERROR: Boot Failure, ID0 not installed or ID Board Failed |
2017-10-11
|
1922246.1 |
Sun Fire[TM] 3800/4800/E4900/6800/E6900 CPU Board failed with Bad checksum POST Segment |
2017-10-18
|
1638658.1 |
Sun Fire[TM] 4800, 4810, 6800, E4900, E6900: Unable to power on power supplies (PS) and fans (FT) in the platform |
2017-10-18
|
1552578.1 |
How to verify Power Supplies Issues In The Sun Cabinet (RTS - RTU) |
2017-10-18
|
1531443.1 |
All memory DIMMS have disabled status in prtdiag output |
2017-10-18
|
1352782.1 |
Excessive PSU temperatures on Sun Fire 4800 and E4900 servers |
2016-12-15
|
1332034.1 |
Unable To Boot The Domain due to "No usable Cpu board or IO board in domain" |
2017-10-18
|
1019667.1 |
Sun Fire[TM] Server System Board (SB) voltage errors. |
2017-10-18
|
1018948.1 |
Sun Fire[TM] Serengeti: System Board power on generates "JTAG part 0x91a0: Substituting version 0x3 for version 0x4" |
2017-02-02
|
1018832.1 |
Sun Fire [TM] SF3800/SF4800/SF4810/SF6800 - E4900/E6900 Server ( Serengeti/Amazon ): POST fails during IOPOST, marking all I/O Boards (IBs) as bad. |
2017-02-02
|
1018813.1 |
Sun Fire [TM] SF3800/SF4800/SF4810/SF6800 - E4900/E6900 Server: Domains running firmware 5.15.x or later with hang-policy set to "notify" may lose critical troubleshooting data |
2017-02-02
|
1018620.1 |
Sun Fire [TM] Midrange Server: inaccurate msg from the SC following a reboot |
2017-02-02
|
1018210.1 |
Sun Fire[TM] Midframe Server:Symptom:Flashupdate fails when user is root-No boards can be updated |
2017-02-02
|
1017987.1 |
Response to error: SepromSegment(constructor): PE at 0x----: Invalid CRC observed=xxxxxxxx expected=yyyyyyyy |
2017-02-02
|
1017844.1 |
Sun[TM] Fire 3800/4800/4810/6800/E2900/E4900/E6900/V1280 and Netra[TM] 1280/1290 Server: I/O Board (IB) power supply failures. |
2017-02-02
|
1017808.1 |
send break does not always work on Sun Fire[TM] platform |
2017-02-02
|
1012439.1 |
DR diag-level is not synced with domain boot parameters diag-level |
2017-10-18
|
1011054.1 |
Sun Fire[TM] v1280, E2900, 3800, 4800, 4810, 6800, E4900, E6900, and Netra 1280, 1290 Server: Missing/Improper Seeprom CPU Speed information. |
2017-02-02
|
1010924.1 |
Sun Fire[TM] Server : Dynamic Reconfiguration (DR) fails due to Real Time (RT) process running. |
2017-02-02
|
1010922.1 |
New US IV board were just added and the OS will not see them properly |
2017-02-02
|
1010901.1 |
Installation of Solaris[TM] 9 04/04 or Solaris[TM] 10 causes domain to panic or ERROR Fast Data Access MMU Miss |
2017-02-02
|
1010380.1 |
Sun Fire[TM] 3800/48x0/6800/E4900/E6900/E2900/V1280 and Netra[TM] 1280/1290 server: Resetting the Platform Administrator's Password |
2017-03-29
|
1009954.1 |
Sun Fire[TM] Midrange Server: Time Jumps When SC Accumulates Extended Uptime |
2017-02-02
|
1009696.1 |
"kstat -p" and "prtdiag -v" may give seemingly different PCI bus speeds for Dual Fast Ethernet and Dual SCSI PCI Adapters |
2017-03-29
|
1009648.1 |
Sun[TM] Fire 3800/4800/4810/6800/E2900/E4900/E6900/V1280 and Netra[TM] 1280/1290 Server: SepromContainer.writeOut: sun.serengeti.I2cException: verify error |
2017-02-02
|
1009467.1 |
How to clear faults in FMA after component replacement on Sun Fire[TM] servers. |
2017-02-02
|
1009381.1 |
Sun Fire[TM] E4900/E6900 server: RTS listed as "not present" in Cabinet |
2017-02-02
|
1009358.1 |
Pending "disabled" status being reported by "showcomponent" command |
2017-02-02
|
1009332.1 |
Sun Fire[TM] 3800, v1280, E2900, 4800, 4810, E4900, 6800 and E6900 and Netra 1280, 1290: Certain Memory Configurations with 5.19.0 and 5.19.1 May panic on boot with init level POST |
2017-02-02
|
1009228.1 |
Sun Fire [TM] SF3800/SF4800/SF4810/SF6800 - E4900/E6900 : System Serial Number(SSN) in showplatform different from SSN on the label. |
2017-10-18
|
1009008.1 |
Sun Fire[TM] 3800, 4800, 4810, 6800, E4900, E6900, V1280, E2900, Netra 1280, or 1290 server: NCPQ_TO workarounds |
2017-02-02
|
1008995.1 |
How to recover a domain on Sun Fire[TM] 3800/4800/4810/4900/6800/6900 Midrange Server that is found in Standby mode. |
2017-02-02
|
1008719.1 |
Resolving Hard Hang Problems on Sun Ultra Servers |
2016-04-15
|
1008672.1 |
Sun Fire[TM] (3800-6800/E2900-E6900/v1280) Server: System Controller Setdate to Daylight Savings Time |
2017-10-18
|
1007782.1 |
Dynamic Reconfiguration or hot plug problems on a QGE HBA (4444A). |
2018-01-03
|
1007666.1 |
Sun Fire[TM] Servers/Solaris[TM] Operating System: CD-ROM Boot Attempt Fails With Error: "Cannot Assemble Drivers for Root" |
2017-02-02
|
1007102.1 |
Sun Fire[TM] 3800/4800/4810/6800/E4900/E6900 Servers: How to reset the OpenBootProm (OBP) Password |
2017-02-02
|
1006864.1 |
Sun Fire[TM] Mid Range and High end servers: Dynamic Reconfiguration for Uniboard removal may cause Lotus Domino server instance(s) to abnormally stop |
2017-02-02
|
1006508.1 |
Sun Fire[TM] V1280/E2900/3800/48x0/E4900/6800/E6900: Prtdiag and showboard display wrong cpu speed. |
2017-02-02
|
1006156.1 |
"ERROR: Can't open boot device" booting CDROM or disk with Sun[TM] Dual FastEthernet / Dual SCSI PCI Card |
2017-02-02
|
1005071.1 |
Sun Fire[TM] Servers (3800/4800/4810/6800/E4900/E6900): I2C communication problem |
2017-02-02
|
1005013.1 |
probe-scsi-all may fail without reset-all on all Sun[TM] Systems |
2017-03-29
|
1004679.1 |
Sun Fire[TM] Servers: setdefaults does not reset local-mac-address? parameter |
2017-10-18
|
1004364.1 |
Sun Fire[TM] Midrange Server: Safari Port Error may be caused by a resetting SC |
2017-02-02
|
1004236.1 |
Unconfigured domains report "current year is 197x" after a reboot of the SC in 2007 |
2017-10-18
|
1004235.1 |
Frame Manager "Service LED" is on but no failures are reported by the system |
2017-10-18
|
1002417.1 |
Missing drv/clone forceload in /etc/system on a system with Emulex cards may cause panic during boot |
2017-02-02
|