How to Replace Old Adapters/Cables on ExAP Ports for SMxG Cards in Order to Support 1 Gbps/Full Duplex?

Asset ID:	1-71-2386169.1
Update Date:	2018-04-18
Keywords:

Solution Type Technical Instruction Sure

Solution 2386169.1 : How to Replace Old Adapters/Cables on ExAP Ports for SMxG Cards in Order to Support 1 Gbps/Full Duplex?

Applies to:

Oracle Communications EAGLE (Software) - Version EAGLE 46.5 and later
Information in this document applies to any platform.

Goal

How to Replace Old Adapters/Cables on ExAP Ports for SMxG Cards in Order to Support 1 Gbps/Full Duplex?

Solution

To replace cables and adapters on ExAP Ports for SMxG Cards (SCCP/SMxG) cards in order to support 1 Gbps/Full Duplex follow next steps:

1) Enter the following command to determine the number of SCCP/SMxG cards that are IS-NR.

rept-stat-sccp

2) Enter the following command to verify current status for involved SCCP/ SMxG card..

rept-stat-card:loc=xxxx

3) Enter the following command to remove the SCCP/SMxG card from service.

inh-card:loc=xxxx

4) Remove current cables/adapters for involved SCCP/SMxG card at Eagle backplane and EPAP’s switch.

5) Insert DSM’s card adapters with P/N 830-1104-XX.

6) Connect cables with P/N 830-1174-XX [Shielded Straight Through Cable (CAT-5)] at Eagle backplane and ExAP’s switch.

7) Enter the following command to return the SCCP/SMxG card into service

alw-card:loc=xxxx

8) Verify that SCCP/SMxG card is IS-NR and its IPLNK/ports are UP:

rept-stat-card:mode=full:loc=xxxx

9) Once DSM card is IS-NR and its IPLNK/ports are UP, repeat steps from 2 to 8 for next SCCP/SMxG card.

References

<NOTE:1597048.1> - Oracle Documentation Links

Attachments

This solution has no attachment