| Asset ID: |
1-71-2308539.1 |
| Update Date: | 2017-09-19 |
| Keywords: | |
Solution Type
Technical Instruction Sure
Solution
2308539.1
:
SL4000/T10000 - T10000 Drive Brick Replacement
| Related Items |
- StorageTek SL4000 Modular Library System
- StorageTek T10000D Tape Drive
|
| Related Categories |
- PLA-Support>Sun Systems>TAPE>Tape Hardware>SN-TP: STK T-Series Drive
|
In this Document
Oracle Confidential PARTNER - Available to partners (SUN).
Reason: Confidential for service personnel
Applies to:
StorageTek SL4000 Modular Library System - Version All Versions and later
StorageTek T10000D Tape Drive - Version All Versions and later
Information in this document applies to any platform.
Goal
How to replace the T10000 Drive Brick in the SL4000 library.
Solution
DISPATCH INSTRUCTIONS
- WHAT SKILLS DOES THE FIELD ENGINEER/ADMINISTRATOR NEED?: Familiar with the SL4000 and T10000 Tape Drive.
- TIME ESTIMATE: 30 minutes
- TASK COMPLEXITY: 2
FIELD ENGINEER/ADMINISTRATOR INSTRUCTIONS:
- PROBLEM OVERVIEW: T1000 tape drive has been determined defective and requires replacement
- WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?: Drive must be offline to the system.
- WHAT ACTION DOES THE FIELD ENGINEER/ADMINISTRATOR NEED TO TAKE?:
Note: Refer to the SL4000 Install and Service Manual for additional details as needed.
Required Tools
T10 driver
T15 driver
Removal
1. Take the drive offline. Remove the drive tray from the library, remove the top cover, and then open the rear cover (see "Drive Tray Removal to Access FRUs" on page 11-10).
2. With the rear cover open, disconnect the cables from the back of the drive (T10000D shown below, other models may differ).
Note: To access the cables, you may need to remove the fan assembly. Loosen the captive screw between the fans, and then lift up.
3. Remove the air-flow shield between the LOD card and the top of the drive.
4. Remove the four T15 screws from the sides of the tray (two on each side).
5. Pull out the drive. Remove and retain the bezel on the front of the drive. Remove and retain the SFP modules (if installed in FC interface ports).
Replacement
1. Install the bezel on the front of the new drive (ensure both sides snap into place). Install the SFP modules (if applicable).
2. Slide the drive fully into the tray.
3. Reinstall the four T15 screws on the sides of the tray (two on each side).
IMPORTANT: Install the screws in the STK position (see "Drive Mounting Hole Locations" on page 11-11).
4. Insert the air flow shield over the drive, ensuring the shied is under the LOD card.
5. Reconnect the cables to the back of the drive, starting with the power cable. Reinstall the fan (if applicable).
6. Secure the rear cover by replacing the four T10 screws.
OBTAIN CUSTOMER ACCEPTANCE
- WHAT ACTION DOES THE FIELD ENGINEER/ADMINISTRATOR NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE?: Bring drive online to the library. Verify the drive is functional to the system.
PARTS NOTE: Components List https://mosemp.us.oracle.com/handbook_internal/Systems/SL4000/components.html
REFERENCE INFORMATION: SL4000 Install and Service Manual http://amomv0115.us.oracle.com/archive/cd_ns/E88746_01/index.html
Attachments
This solution has no attachment
