Sun Microsystems, Inc.  Oracle System Handbook - ISO 7.0 May 2018 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Asset ID: 1-71-2259513.1
Update Date:2017-04-27
Keywords:

Solution Type  Technical Instruction Sure

Solution  2259513.1 :   Diameter Signaling Router - Set Ring Buffer Sizes Failed On DL380Gen9  


Related Items
  • Oracle Communications Diameter Signaling Router (DSR)
  •  
Related Categories
  • PLA-Support>Sun Systems>CommsGBU>Global Signaling Solutions>SN-SND: Tekelec DSR
  •  




In this Document
Goal
Solution


Created from <SR 3-14760389911>

Applies to:

Oracle Communications Diameter Signaling Router (DSR) - Version DSR 7.2.0 and later
Tekelec

Goal

In doc:

http://docs.oracle.com/cd/E68457_01/docs.72/E64707_rev_02.pdf

Performed the procedure 5 but errors message appeared as below by applying the commands on eth01, eth02, eth05 and eth06.

(Bond0 = eth01,eth02 / Bond1 = eth05,eth06).

[root@hostname upgrade]# netAdm set --device=eth05 --ringBufferRx=4096 --ringBufferTx=4096
ERROR: Desired ringBufferRx: 4096 Actual: 200
ERROR: Specified ethtool_opts could not be set!
ERROR: Failed to bring eth05 back up
ERROR: Failed to restart eth05
Interface eth05 updated

  

Solution

Ehternet cards being used are not the intended ones

Lets revisit the document
http://docs.oracle.com/cd/E68457_01/docs.72/E64707_rev_02.pdf
Procedure 5, Step 8 Says:
  The following commands will increase the ring buffer sizes on...HP DL380 Gen 9 Ethernet Interfaces:
  Note: Refer to Section 3.4 for network interface server reference table

Now looking at Section 3.4
 Note:
 For HP DL380 Gen 9 servers
 two 2pt 10 Gigabit PCI cards are required while running the segregated signaling network topology
 otherwise one 2pt 10 Gigabit PCI card is required

 For HP DL380 (with 2pt 10 Gigabit in PCI Slots 1 and 3) (Gen 9)
 Following network interfaces have been mentioned:
 <ethernet_interface_1> eth11 (ethernet slot 1, port 1)
 <ethernet_interface_2> eth12 (ethernet slot 1, port 2)
 <ethernet_interface_3> eth31 (ethernet slot 3, port 1)
 <ethernet_interface_4> eth32 (ethernet slot 3, port 2)


From available information the HPGen9 built in 1Gb ethernet cards are used while document is expecting 2 port 10 Gigabit Cards.

Check if the server has 10 Gb PCI card available as required in section 3.4 (and mentioned above)

Refer to following document about HP DL380 Gen9 Servers

Oracle Communications Diameter Signaling Router Release 7.4 Planning Guide >> Page 51 >> Table 43: HP Gen9 Configuration Options
 


Attachments
This solution has no attachment
  Copyright © 2018 Oracle, Inc.  All rights reserved.
 Feedback