Sun StorageTek SL8500 Modular Library System
 

PLA-Support>Sun Systems>TAPE>Tape Hardware>SN-TP: SL3000-8500 Library
 

The customer needs to change the IP address of the hosts connecting to the SL8500 and wishes to know what changes are required to the SL8500.

In this Document

Goal

Solution

References

Created from <SR 3-8640214521>

Applies to:

Goal

Customer wishes to change the host IP addresses and wants to know what changes will be needed on the SL8500.
 

Solution

It is not possible to say what changes are required for a host IP address change without full details of the customer network.  However, you should run the following commands from the SL8500 CLI and review the network settings in the light of the new host IP address changes. The network administrators will be able to advise on any changes required (routers etc). You are also advised to consult the SL8500 Host Connectivity Guide. E35821-0x.

 Display the configured network settings and save these information for later use.
  On the CLI prompt, run these commands:
  
  When Dual-TCP feature is enabled:
  SL8500> network ip address show

  For a single port configuration:
  SL8500> network print

  If static routes and policy routes are currently defined, also run the following:
  SL8500> network ip route show
  SL8500> network ip policy status
  SL8500> network ip policy route show dev 2B
  SL8500> network ip policy route show dev 2A
 

References

This solution has no attachment