Sun Blade 150 Workstation
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
 

In this Document

Goal

Solution

Applies to:

Goal

  Sun Blade 150, How to replace DVD/CD-ROM Drive

Solution

DISPATCH INSTRUCTIONS


WHAT SKILLS DOES THE FIELD ENGINEER/ADMINISTRATOR NEED:
No special skills required, Customer Replaceable Unit (CRU) procedure

TASK COMPLEXITY: 0

TIME ESTIMATE: 40 minutes

REMOVAL/REPLACEMENT INSTRUCTIONS

PROBLEM OVERVIEW: DVD/CD-ROM Drive

OBTAIN CUSTOMER ACCEPTANCE

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

A data backup is not a pre-requisite but is a wise precaution.
The customer should conduct an orderly software system shutdown.

 WHAT ACTIONS ARE REQUIRED:

1. Remove any CD or DVD from the drive.
2. Power off the system, remove the system cover, and attach an antistatic wrist strap

Caution – Use proper ESD grounding techniques when handling components. Wear
an antistatic wrist strap and use an antistatic mat. Store ESD-sensitive components in
antistatic bags before placing them on any surface.
3. Remove the following from the back of the CD-ROM or DVD-ROM drive

* CD-ROM or DVD-ROM drive IDE cable connector
* Power cable connector

4. Using a No. 2 Phillips screwdriver, remove the two screws securing the CD-ROM or DVD-ROM drive to the chassis.
5. Place your fingers on the back of the CD-ROM or DVD-ROM drive. Push the CD-ROM or DVD-ROM drive toward the chassis front and remove it


Replacing a CD-ROM or DVD-ROM Drive

Note – Before you replace the CD-ROM or DVD-ROM drive, verify that the drive back panel mode-select jumper is set to “CS,”“Enable Cable Select,
or “Cable Select.”

1. Position the CD-ROM or DVD-ROM drive in the chassis
2. Push the CD-ROM or DVD-ROM drive toward the chassis rear.
3. Connect the following to the rear of the CD-ROM or DVD-ROM drive:

* CD-ROM or DVD-ROM drive cable connector
* Power cable connector

Note – Ensure that the cable assembly connectors are properly oriented by aligning the connector keys.

4. Using a No. 2 Phillips screwdriver, replace the two screws securing the CD-ROM or DVD-ROM drive to the chassis.
5. Detach the wrist strap, replace the system cover, and power on the system

WHAT ACTIONS ARE REQUIRED TO RETURN the SYSTEM TO AN OPERATIONAL STATE:

Restart software applications per applicable administration guides to resume system operation.

PARTS NOTE: Include Sun Blade 150 DVD or CR-ROM Drive:

https://support.oracle.com/handbook_private/Systems/SunBlade150/components.html

ADDITIONAL COMMENTS:

Please refer to the Sun Blade 150 Service Manual http://docs.oracle.com/cd/E19127-01/blade150.ws/816-4379-10/816-4379-10.pdf

This solution has no attachment