Sun Fire V120 Server
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
 

In this Document

Goal

Solution

Applies to:

Goal

  Sun Fire V120, How to replace DVD/CD-ROM Drive

Solution

DISPATCH INSTRUCTIONS


WHAT SKILLS ARE REQUIRED:
No special skills required, Customer Replaceable Unit (CRU) procedure

TASK COMPLEXITY: 0

TIME ESTIMATE: 40 minutes

REMOVAL/REPLACEMENT INSTRUCTIONS

PROBLEM OVERVIEW: DVD/CD-ROM Drive

OBTAIN CUSTOMER ACCEPTANCE

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

A data backup is not a pre-requisite but is a wise precaution.
The customer should conduct an orderly software system shutdown.

 WHAT ACTIONS ARE REQUIRED:

Installing a DVD or CD-ROM Drive

Note – If you are going to install a full-length PCI card, install the DVD or CD-ROM drive first. If you have a full-length PCI card already installed, you need to
remove it before installing the DVD or CD-ROM drive.

1. Remove the top cover. Make sure you disconnect all power cables and wear an antistatic wrist strap.
2. Remove the front bezel. Release it from the server by pressing in on the tabs at either end of the bezel.
3. If you have a full-length PCI card installed, you must remove it before installing the DVD or CD-ROM drive.
4. Squeeze and pull out the filler panel at the front of the DVD or CD-ROM enclosure.

5. Carefully insert the DVD or CD-ROM drive into the chassis. Make sure that the catch at the rear of the DVD or CD-ROM drive clicks onto the
chassis. Guide the drive in so that its connectors align with, and then engage with,the connectors on the paddleboard at the back of the drive’s
enclosure in the chassis. You may need to hold the paddleboard by the black IDE connector to guide the DVD or CD-ROM drive home.
6. Re-install the full-length PCI card if you removed one
7. Replace the server’s cover and tighten the captive screw
8. Replace the front bezel.

Removing a DVD or CD-ROM Drive
1. Remove the top cover. Make sure you disconnect all power cables and wear an antistatic wrist strap.
2. Remove the front bezel. Release it from the server by pressing in on the tabs at either end of the bezel.
3. Unclip the catch that fastens the DVD or CD-ROM drive to the chassis. This catch is located at the back right-hand corner of the drive’s casing.
4. Carefully but firmly pull the DVD or CD-ROM drive out of its connector at the rear of the enclosure and pull the drive out of the chassis.
5. Close the server cover and tighten the captive screw
6. Close the front bezel.

WHAT ACTIONS ARE REQUIRED TO RETURN the SYSTEM TO AN OPERATIONAL STATE:

Restart software applications per applicable administration guides to resume system operation.

PARTS NOTE: Include Sun Fire V120 DVD or CR-ROM Drive:

https://support.oracle.com/handbook_private/Systems/SunFireV120/components.html

ADDITIONAL COMMENTS:

Please refer to the Sun Fire V120 and Netra 120 Server User's Guide: http://docs.oracle.com/cd/E19088-01/v120.srvr/816-2090-10/816-2090-10.pdf

This solution has no attachment