Mx-32 - How to Replace a Front/Rear Cabinet Door

Asset ID:	1-71-1542451.1
Update Date:	2016-01-20
Keywords:

Solution Type Technical Instruction Sure

Solution 1542451.1 : Mx-32 - How to Replace a Front/Rear Cabinet Door

Applies to:

SPARC M5-32 - Version All Versions and later
Oracle SuperCluster M6-32 Hardware - Version All Versions and later
SPARC M6-32 - Version All Versions and later
Information in this document applies to any platform.

Goal

CAP PROBLEM OVERVIEW: Mx-32 - Front/Rear Cabinet Door

To report errors or request improvements on this procedure, please go to My Oracle Support, and put a comment on Doc ID: 1542451.1

ESD Caution:

Circuit boards and drives contain electronic components that are extremely sensitive to static electricity. Ordinary amounts of static electricity from clothing or the work environment can destroy the components located on these boards. Do not touch the components along their connector edges.
Use a Antistatic Wrist strap. Attach one end of the strap to your wrist and the other end to the chassis, depending on what type of strap you use, with the adhesive end or the metal plug.
Use an Antistatic Mat. Place ESD-sensitive components such as motherboards, memory, and other PCBs on an antistatic mat.

Contamination Caution:

Dust particles of packaging material are number one cause of datacenter contamination. Make sure to remove all packaging material, up to the ESD safe packaging material, while still being outside the datacenter.

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED: Mx-32 Product Training/Experience

TASK COMPLEXITY: 1

TIME ESTIMATE: 60 minutes

HOT replacement

FIELD ENGINEER INSTRUCTIONS

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? : n.a.

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:

Active Replacement:

The front and rear cabinet doors are nearly identical and can be removed or installed in the same way.

Remove a Cabinet Door:

1. Disconnect the ground cable from the cabinet.

Keep the ground cable attached to the door.

2. Remove the door as follows:

a. Loosen the T20 screws on the upper hinge bracket.

Do not remove the screws.

b. Hold the top of the door to keep it from falling, then lift the upper mounting bracket to release the door.

c. Lift the door off the lower hinge pin and set the door aside.

Install a Cabinet Door:

1. Install the door as follows:

a. Loosen the T20 screws (2) on the upper mounting bracket.

Do not remove the screws.

b. Place the door on the lower hinge pin.

c. Lift the upper mounting bracket, then lower the hinge pin (1) into the hole in the top of the door.

d. Verify that the door can swing freely while you tighten the T20 screws on the upper mounting bracket.

2. Connect the ground cable from the door to the cabinet.

OBTAIN CUSTOMER ACCEPTANCE

Attachments

This solution has no attachment