How to Remove and Replace Midrange Disk 6140 Power Supply Unit (PSU) [Video]

Asset ID:	1-71-1524231.1
Update Date:	2016-08-19
Keywords:

Solution Type Technical Instruction Sure

Solution 1524231.1 : How to Remove and Replace Midrange Disk 6140 Power Supply Unit (PSU) [Video]

Applies to:

Sun Storage 6140 Array - Version All Versions and later
Information in this document applies to any platform.

Goal

How to Remove and Replace a 6140 PSU (Power Supply Unit) using CAM (Common Array Manager).

Solution

Video - How to Remove and Replace 6140 Power Supply Unit (1:34)

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE FIELD ENGINEER/ADMINISTRATOR NEED?:

Has gone through basic 2500/6000 Array Hardware Introduction
Common Array Manager

TIME ESTIMATE: 15 minutes
TASK COMPLEXITY: 0

FIELD ENGINEER/ADMINISTRATOR INSTRUCTIONS:

PROBLEM OVERVIEW: 6140 PSU has failed or has been identified as faulty.

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?:

The PSU is in a failed state or has been identified as being faulty.

WHAT ACTION DOES THE FIELD ENGINEER/ADMINISTRATOR NEED TO TAKE?:

NOTE: If ASR is enabled, it should be deactivated temporarily before servicing the equipment so that additional unnecessary Service Requests are not created.

DEACTIVATING ASR WITH CAM 6.10: ASR is automatically deactivated when you select "Reserve the tray for maintenance" in Service Advisor, and it is reactivated when you select "Release the tray from maintenance" in Service Advisor.

DEACTIVATING ASR WITH CAM 6.9 OR EARLIER: Before proceeding with the part replacement:

1. Log into CAM.
2. Go to "Storage Systems" -> [your arrayname] -> "Administration" -> "Array Health Monitoring".
3. Uncheck the box "Enable ASR for this array" under the section "Monitoring for This Array". If the box is already unchecked, there is no action required. Remember the status however, as it will matter in step 3 of REACTIVATING ASR WITH CAM 6.9 OR EARLIER below.
4. Click on "Save" if you have unchecked the box in step 3 above.

1. Log into CAM and open the Service Advisor.
2. Under the Power-Fan Removal/Replacement, select the tray and power supply.
3. Follow the PSU Replacement Instructions therein.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE FIELD ENGINEER/ADMINISTRATOR NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:

1. Verify that no critical faults exist on the system

REACTIVATING ASR with CAM 6.10: ASR is automatically deactivated when you select "Reserve the tray for maintenance" in Service Advisor, and it is reactivated when you select "Release the tray from maintenance" in Service Advisor. If ASR was not enabled before beginning this procedure, selecting "Release the tray from maintenance" will not activate it.

REACTIVATING ASR WITH CAM 6.9 OR EARLIER: After proceeding with the part replacement:

1. Log into CAM.
2. Go to "Storage Systems" -> [your arrayname] -> "Administration" -> "Array Health Monitoring".
3. Check the box "Enable ASR for this array" under the section "Monitoring for This Array". Do this ONLY if you unchecked the box in step 3 of DEACTIVATING ASR WITH CAM 6.9 OR EARLIER. If you found the box was unchecked, leave it unchecked now.
4. Click on "Save" if you have checked the box to reactivate ASR.

REFERENCE INFORMATION: CAM Service Advisor

Attachments

This solution has no attachment