Sun Netra 240 (DC) Server
 
Sun Netra 240 (AC) Server
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
 

In this Document

Goal

Solution

Removing a PCI Card

Installing a PCI Card

Applies to:

Goal

Netra 240 -  How to Remove and Replace a Netra 240 PCI Card

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS ARE REQUIRED:

No special skills required, Customer Replaceable Unit (CRU) procedure

TIME ESTIMATE: 30 minutes

TASK COMPLEXITY: 0

REMOVAL/REPLACEMENT INSTRUCTIONS:

PROBLEM OVERVIEW: Faulty PCI Card

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?:

A data backup is not a pre-requisite but is a wise precaution.
The customer should conduct an orderly software system shutdown.

WHAT ACTIONS ARE REQUIRED:

The following procedures describe how to remove and install individual PCI cards into the Netra 240 server.

Removing a PCI Card

1.Power off the server.

2.Remove the server cover.

3.Open the rotating service module.

4.Ensure that the server is properly grounded.

5. Completely remove the air duct and rear fan assembly.

6. Using a No. 2 Phillips screwdriver, unscrew the PCI lock down screw on the back of the server

7. Remove the PCI lockdown bracket on the inside of the server

8. Determine which of the PCI cards you are removing from the server:

 - If you are removing one of the two half-length PCI cards installed in the upper positions (PCI1 or PCI2), unseat the PCI card from the connector and lift it out of the server

 - If you are removing the full-size PCI card at the lowest position (PCI0), follow these instructions:

  - Pull up on the handle for the PCI card support and slide the support clear of the PCI card

  - Unseat the PCI card from the connector and lift it out of the server

Installing a PCI Card

1. Insert the PCI card in the appropriate slot and press it firmly into its connector.

 - If you are installing the lower full-length PCI card, pull up on the handle for the PCI card support and slide the PCI card support completely against the PCI card

2. Reattach the PCI lockdown bracket and tighten the PCI lockdown screw

3. Install the air duct and rear fan assembly.

4. Close the rotating service module.

5. Install the server cover.

6. Power on the server.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTIONS ARE REQUIRED TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:

Bring system back up to a functioning state.
Restart software applications per applicable administration guides to resume system operation.

PARTS NOTE:

https://support.oracle.com/handbook_private/Systems/Netra_240_R/components.html

https://support.oracle.com/handbook_private/Systems/Netra_240/components.html

REFERENCE INFORMATION:

Please refer to the Netra 240 Server Service Manual: http://docs.oracle.com/cd/E19102-01/n240.srvr/817-2699-13/817-2699-13.pdf

This solution has no attachment