How to Replace a Netra T2000 Drive Cluster Assy:ATR:1464860.1:1

Asset ID:	1-71-1464860.1
Update Date:	2017-09-20
Keywords:

Solution Type Technical Instruction Sure

Solution 1464860.1 : How to Replace a Netra T2000 Drive Cluster Assy:ATR:1464860.1:1

Applies to:

Sun Netra T2000 Server - Version Not Applicable and later
Information in this document applies to any platform.

Goal

How to Replace a Netra T2000 Drive Cluster Assy

********************************************************************************
To report errors or request improvements on this procedure,
please go to http://support.us.oracle.com and put a comment on Doc ID: 1464860.1
********************************************************************************

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
Basic Sun hardware FE skills, familiarity or training for T2000 platform.

TIME ESTIMATE: 60 Minutes

TASK COMPLEXITY: 1

FIELD ENGINEER INSTRUCTIONS

PROBLEM OVERVIEW: Netra T2000 Drive Cluster Assy

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?
Customer should shut the operating system down gracefully (using "init 5"), and after the system has shut down run the following commands from the ALOM:

1. setlocator on
2. poweroff

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:

Remove the Drive Cluster Assy:

1. Remove the top cover

2. Remove the optical media drive and the hard drives.

3. Disconnect the cables from the Drive Cluster assembly

4. Move the cables as far out of the way as possible.

5. Loosen both the screw at the back of the Drive Cluster assembly and at the front of the chassis.

6. Slide the Drive Cluster assembly back, pivot the back end up, and lift the assembly out of the chassis

Install the Drive Cluster Assy:

1. Move the cables as far out of the way as possible.

2. Pivot the front of the Drive Cluster assembly down and lower it into the chassis, sliding it forward

3. Tighten the screws at the front of the chassis and the back of the Drive Cluster bracket

4. Connect the following cables to the Drive Cluster assembly

5. Install the optical media drive and the hard drives.

6. Install the top cover

OBTAIN CUSTOMER ACCEPTANCE:

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE: N/A

PARTS NOTE: 2/4 Drive Base Chassis - https://support.oracle.com/handbook_private/Systems/Netra_T2000/components.html#exploded_view

REFERENCE INFORMATION: http://docs.oracle.com/cd/E19596-01/index.html

Attachments

This solution has no attachment