| Asset ID: |
1-71-1464847.1 |
| Update Date: | 2016-01-20 |
| Keywords: | |
Solution Type
Technical Instruction Sure
Solution
1464847.1
:
How to Replace a Netra T2000 LED Board:ATR:1464847.1:1
| Related Categories |
- PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: SPARC-CAP VCAP
|
Oracle Confidential (INTERNAL). Do not distribute to customers.
Reason: FRU CAP
Applies to:
Sun Netra T2000 Server - Version Not Applicable and later
Information in this document applies to any platform.
Goal
How to Replace a Netra T2000 LED Board
********************************************************************************
To report errors or request improvements on this procedure,
please go to http://support.us.oracle.com and put a comment on Doc ID: 1464847.1
********************************************************************************
Fix
DISPATCH INSTRUCTIONS
WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
FE hardware skills, familiarity or training for T2000 platform.
TIME ESTIMATE: 30 minutes
TASK COMPLEXITY: 1
FIELD ENGINEER INSTRUCTIONS
PROBLEM OVERVIEW: Replacement of LED board
WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :
Customer should shut the operating system down gracefully (using "init 5"), and after the system has shut down run the following commands from the ALOM:
1. setlocator on
2. poweroff
WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
Remove the LED board:
1. Verify the system has been shut down by the customer.
2. Remove top cover
3. Remove PCI Tray
4. Remove DIMM/CPU air duct
5. Remove the fan assy.
6. Loosen the thumbscrew of the LED board and swing the board out to the left.
7. Carefully lift the LED board and cable from the cable clips.
8. Disconnect the cable from the LED board
Install new LED board:
1. Connect the cable to the LED board.
2. Insert the tab on the LED board into the slot on the chassis
3. Swing the LED board right to the chassis and tighten the thumbscrew.
4. Route the LED board cable back into the cable guides.
5. Install the fan assembly.
6. Install the DIMM/CPU duct.
7. Install PCI Tray
8. Replace the top cover.
OBTAIN CUSTOMER ACCEPTANCE:
Visually inspect the new LED/Switch board.
WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE: N/A
PARTS NOTE: https://support.oracle.com/handbook_private/Systems/Netra_T2000/components.html#exploded_view
REFERENCE INFORMATION: http://docs.oracle.com/cd/E19596-01/index.html
Attachments
This solution has no attachment
