Pillar Axiom: Adding and/or Replacing an iSCSI HBA card

Asset ID:	1-71-1453837.1
Update Date:	2014-12-10
Keywords:

Solution Type Technical Instruction Sure

Solution 1453837.1 : Pillar Axiom: Adding and/or Replacing an iSCSI HBA card

Applies to:

Pillar Axiom 600 Storage System - Version Not Applicable to Not Applicable [Release N/A]
Pillar Axiom 500 Storage System - Version Not Applicable to Not Applicable [Release N/A]
Information in this document applies to any platform.

Goal

This explains how to install or replace iSCSI HBA add-on cards

To discuss this information further with Oracle experts and industry peers, we encourage you to review, join or start a discussion in the My Oracle Support Community - Disk Storage Pillar Axiom System

Solution

Customers may refer to the online Service Guide available through the Axiom GUI under the Support Tab > Technical Documentation > Service Guide.
1) Once you open up the link, do a keyword search for iSCSI.
2) This will bring a search to the section for adding a PCiX Riser card, and the slots they best go into.
3) If only one iSCSI card is being replaced, then using the NIM replacement using Guided Maintenance will be sufficient, and avoids the need to bring the whole Axiom system down.
4) If both iSCSI cards are being added/replaced on a Slammer, then another option would be to place the Axiom in Shutdown state, thereafter powering it off. Replacement of the 2 cards can be done without the use of Guided Maintenance. Power on the system thereafter.

Attachments

This solution has no attachment