Sun ZFS Storage 7320
 
Oracle ZFS Storage ZS3-BA
 
Sun Storage 7210 Unified Storage System
 
Oracle SuperCluster M6-32 Hardware
 
Oracle SuperCluster T5-8 Hardware
 
Oracle ZFS Storage ZS3-2
 
Sun Storage 7410 Unified Storage System
 
Oracle ZFS Storage ZS3-4
 
SPARC SuperCluster T4-4 Half Rack
 
Sun ZFS Storage 7420
 
Oracle ZFS Storage ZS4-4
 
SPARC SuperCluster T4-4
 
Sun Storage 7310 Unified Storage System
 
SPARC SuperCluster T4-4 Full Rack
 
Exalogic Elastic Cloud X4-2 Half Rack
 
PDIT Single Rack ZFS Storage ZS4-4
 
Sun ZFS Storage 7120
 
Sun ZFS Backup Appliance
 
Sun Storage 7110 Unified Storage System
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: DISK-CAP VCAP
 
Microlearning>Video>ML-VID-VCAP
 

In this Document

Goal

Solution

References

Applies to:

Goal

How To Replace A PSU In The Oracle ZFS Storage ZS3 Or Sun Storage 7000 Series

Solution

DISPATCH INSTRUCTIONS

- WHAT SKILLS ARE REQUIRED?: No special skills required, Customer Replaceable Unit (CRU) procedure

- TIME ESTIMATE: 30 minutes

- TASK COMPLEXITY: 0

- PROBLEM OVERVIEW
What: The power supply in the NAS needs replacement
Where: Chassis S/N: , PSU Slot No. of the device to be inserted here by SR owner
Why : The PSU has failed in the NAS and should have an amber light on it.

REPLACEMENT INSTRUCTIONS

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?
No downtime needs to be scheduled, and the system can be in full production as they are redundant.

WHAT ACTIONS ARE REQUIRED?:

1. Locate the PSU by amber LED.

The following LEDs are lit when a power supply fault is detected:

* Front and rear Service Required LEDs
* Rear PS Failure LED on the bezel of the server
* Failure LED on the faulty power supply

2. Take ESD Precautions.

3. Check the PSU part numbers for the appropriate system in the System Handbook and re-confirm.

4. Removing the Power Supply as follows or use the "online" Help Guide.
* If present, remove cable management arm, or swivel open cable management arm to view power supplies.
* Disconnect the AC power cord that is connected to power supply you want to replace.
* Remove installed power supply unit by pulling its handle downward until it disengages unit from
connector on PDB. Pull out power supply.

5. Installing the Power Supply as follows or use the "online" Help Guide.
* Align power supply with empty bay in chassis.
*With power supply handle in down position, push power supply into power supply bay.
* Connect AC power cord to new power supply. Use the power cord retaining clips.
*If present, swivel cable management arm back into closed position.

6. Verify the replacement by checking for Green LED

WHAT ACTIONS ARE REQUIRED TO RETURN THE SYSTEM TO AN OPERATIONAL STATE?:

Confirm there are no faults reported in the appliance BUI. Mark "Repaired" any prior faults related to the PSU

PARTS NOTE:

Please refer to the FE handbook for all PSU part number for conformation of correct type.

EXTERNAL REFERENCES:

Oracle Unified Storage Systems Documentation :

http://www.oracle.com/technetwork/documentation/oracle-unified-ss-193371.html

Sun ZFS Storage Appliances Troubleshooting Resource Center (Doc ID 1416406.1)

References

This solution has no attachment