How to Replace an Ultra 24 Workstation System Battery

Asset ID:	1-71-1349690.1
Update Date:	2016-04-14
Keywords:

Solution Type Technical Instruction Sure

Solution 1349690.1 : How to Replace an Ultra 24 Workstation System Battery

Applies to:

Sun Ultra 24 Workstation - Version All Versions to All Versions [Release All Releases]
Information in this document applies to any platform.

Goal

How to Remove and Replace a Ultra 24 Workstation System Battery

Solution

DISPATCH INSTRUCTIONS
- WHAT SKILLS ARE REQUIRED?: No special skills required, Customer Replaceable Unit (CRU) procedure
- TIME ESTIMATE: 60 minutes
- TASK COMPLEXITY: 0

REMOVAL/REPLACEMENT INSTRUCTIONS:
- PROBLEM OVERVIEW: How to Remove and Replace a Ultra 24 Workstation System Battery
- WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?: Shut down the system
- WHAT ACTIONS ARE REQUIRED?:

Remove the System Battery

1. Powering Off the System and Removing the Left-Side Access Panel.
I. Power off the system and all the peripherals connected to it.
II. Turn the power switch on the back of the chassis to the Off position.

caution icon Caution - Failure to properly turn off the system before you start installing components can cause serious component damage.

   III. To maintain system grounding, do not unplug the AC power cord from the back of the system unless the specific procedure instructs you to unplug it.
   IV. Loosen the two captive thumbscrews located on the rear edge of the left side access panel
   V. Slide the access panel approximately 1.5 cm toward the back of the workstation.
   VI. Tilt the top edge of the panel out, then lift the panel upward.
   VII. Carefully set the panel aside.

Caution - If you remove the system battery, you could erase all system-specific information saved in the CMOS.

Replace the System Battery

1. Use a flat-blade screwdriver to lift and abruptly release the battery latch. This action releases and removes the battery
2. Install the new battery .
3. With the positive sign (+) facing up, push the battery into the battery connector until it clicks into place (see FIGURE 5-21).

- WHAT ACTIONS ARE REQUIRED TO RETURN THE SYSTEM TO AN OPERATIONAL STATE?: Power on the system, and verify the installation

PARTS NOTE:

REFERENCE INFORMATION:

Sun Ultra 24 Workstation Service Manual
http://download.oracle.com/docs/cd/E19127-01/ultra24.ws/820-2480-12/

Attachments

This solution has no attachment