Sun Fire X2200 M2 Server
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: x64-CAP VCAP
 

In this Document

Goal

Solution

Applies to:

Goal

How to Replace a Sun Fire X2200 M2 Dual Blower Module.

Solution

CAP PROBLEM OVERVIEW: How to Remove and Replace Dual Blower Module

WHAT SKILLS DOES THE ENGINEER NEED?
ESD Awareness and basic hardware competence

Task Complexity: 0

Time Estimate: 90 minutes

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE
RESOLUTION ACTIVITY?

Power off the system and remove the cover.
o Remove the single fan connectors from the harness connectors.
o Note exactly which motherboard connector to which the fan was connected. If you connect a fan to an incorrect connector, the SP cannot correctly identify a fan failure.
o Push in the green tabs on both sides of the dual blower module and simultaneously pull the fan module upward to remove it.
o Unplug the fan power connector from the motherboard.

To Install a Dual Blower Module

o Position the dual fan module so that it fits over the guideposts and the duct opening fits into the cutouts in the chassis divider.
o Gently push the blower module down, until you hear the side tabs click into place.
o Connect the blower connectors to the appropriate connector on the motherboard.
o Connect each of the single fan connectors to the corresponding fan harness connector.
o Route the cables through the wiring retainers on the blower module.
o Check the routing of all cables for obstructions, and then reinstall the cover.


7. WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM
TO AN OPERATIONAL STATE?
Power the system on

8. ANY PARTS NOTES?

9. REFERENCE INFORMATION
http://download.oracle.com/docs/cd/E19121-01/sf.x2200m2/819-6597-12/index.html

This solution has no attachment