How to Replace Sun Ultra 40 Workstation Removable Media Drive

Asset ID:	1-71-1342302.1
Update Date:	2015-04-02
Keywords:

Solution Type Technical Instruction Sure

Solution 1342302.1 : How to Replace Sun Ultra 40 Workstation Removable Media Drive

Applies to:

Sun Ultra 40 Workstation - Version Not Applicable to Not Applicable [Release N/A]
Sun Ultra 40 M2 Workstation - Version Not Applicable and later
Information in this document applies to any platform.

Goal

How to Replace Sun Ultra 40 Workstation Removable Media

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED:
Sun Ultra 40 Product Knowledge/Training

TIME ESTIMATE: 60 minutes

*FIELD ENGINEER INSTRUCTIONS*

PROBLEM OVERVIEW:
Removable Media failure.

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY?

This is a cold swap procedure. The system should be shutdown by the customer or their system administrator then powered off.

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:

Note: Follow ESD precautions use an anti-static mat and wrist strap.

Removing the I/O Module From the Chassis
1. Confirm system is powered off, open and position the chassis, and remove the access panel.
2. Using the handle, pull the fan tray from the chassis and set it aside.
3. Disconnect the following cables from back of the I/O module:
     ■ DVD dual drive signal cable
     ■ Audio/power cable
     ■ USB signal cable
4. Push in the I/O module release latch.
5. Pull the I/O module out from the front of the workstation chassis.
6. Place the I/O module down on an antistatic mat.
7. Remove the new I/O module from its packaging.

Replacing the I/O Module in the Chassis
1. Slide the I/O module back into the front of the workstation chassis.
2. Connect the following cables to the I/O module:
     ■ DVD dual drive signal cable
     ■ Audio/power cable
     ■ USB signal cable
3. Inspect the cabling to verify that all connectors are firmly connected at both ends.
4. Slide the fan tray back into the chassis.
5. Install the side cover and the access panel, power on the system, and verify the installation.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:
Restart software applications per applicable administration guides to resume system operation.

REFERENCE INFORMATION:

See Chapter 6.3 Replacing the DVD Dual Drive and I/O Module (Sun Ultra 40 Workstation Service Manual)

Sun Ultra 40 Workstation Service Manual
http://download.oracle.com/docs/cd/E19127-01/ultra40m2.ws/820-0123-13/

Attachments

This solution has no attachment