How to Replace a Sun Enterprise/Fire T1000 Server Power Supply Unit:ATR:1333660.1:0

Asset ID:	1-71-1333660.1
Update Date:	2016-08-18
Keywords:

Solution Type Technical Instruction Sure

Solution 1333660.1 : How to Replace a Sun Enterprise/Fire T1000 Server Power Supply Unit:ATR:1333660.1:0

Applies to:

Sun Fire T1000 Server - Version Not Applicable to Not Applicable [Release N/A]
Sun SPARC Enterprise T1000 Server - Version Not Applicable and later
Information in this document applies to any platform.

Goal

How to Replace a Sun Fire/Sun Enterprise T1000 Server Power Supply Unit

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS ARE REQUIRED
No special skills required, Customer Replaceable Unit (CRU) procedure

DELIVERY REQUIREMENT:
Schedule for immediate replacement within contractual terms.

TIME ESTIMATE: 90 minutes

TASK COMPLEXITY: 0

REMOVAL/REPLACEMENT INSTRUCTIONS

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

DAMAGE ALERT: Perform a visual inspection of the replacement part to make sure that there are no damaged components, connectors, bent pins, damaged packages during shipping, etc. If the part is damaged, don't install it into the system, order a new part. Handle with caution and package carefully the return part to avoid any damages during shipping.

The customer should conduct an orderly software and system shutdown.
System power off is required.

WHAT ACTIONS ARE REQUIRED:

1. Ensure system is shut down

2. Follow instructions in chapter 4 (Sun Fire T1000 Server Service Manual) to prepare the system for service.

The chassis cover might be very difficult to remove. If you press too hard on the cover lock button, the front edge of the cover might warp and bind. Also, elastic gasket material on the sides of the chassis might prevent the cover from sliding freely.

To work around this, lightly hold down the cover lock button and push the cover slightly toward the front of the chassis (this assists the unlocking action), then slide the cover approximately one half inch (12 mm) toward the rear of the chassis. You can now lift the cover off the chassis.

3. Disconnect the power cable from the motherboard and pull the cable through the midwall.

4. Pull the fastener up on the front of the power supply and remove the power supply from the chassis.

5. Unpack the replacement power supply.

6. Slide the power supply into the chassis and engage the two alignment pins in the rear of the chassis that mate with the power supply.

7. Push the fastener down on the front of the power supply to lock it into place in the chassis.

8. Redress the power cable through the midwall in the chassis and connect the cable to the motherboard.

9. Follow instructions in Chapter 6 (Sun Fire T1000 Server Service Manual) to finish up hardware servicing.

10. Verify the status of the power supply.

sc> showenvironment

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTIONS ARE REQUIRED TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:

Power on the server.

PARTS NOTE:

Sun Fire T1000 https://support.oracle.com/handbook_private/Systems/SunFireT1000/components.html#Power

Sun Enterprise T1000 https://support.oracle.com/handbook_private/Systems/SE_T1000/components.html#Power

REFERENCE INFORMATION:

Sun Fire T1000 Server Service Manual

Attachments

This solution has no attachment