Sun Fire X4270 M2 Server
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: x64-CAP VCAP
 

In this Document

Goal

Solution

Oracle Confidential PARTNER - Available to partners (SUN).
Reason: FRU CAP

Applies to:

Goal

How to Replace a Sun Fire X4270 M2 Rear Disk Drive Cage.

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE FIELD ENGINEER/ADMINISTRATOR NEED?:
Sun Fire X4270 M2 Training

TIME ESTIMATE: 90 minutes

TASK COMPLEXITY: 1

FIELD ENGINEER/ADMINISTRATOR INSTRUCTIONS:

PROBLEM OVERVIEW: A Sun Fire X4270 M2 Rear Disk Drive Cage needs replacement

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

1. Prepare the server for service.
   a. Power off the server and disconnect the power cord (or cords) from the power supply (or supplies).
   b. Remove the server from the rack.
   c. Attach an antistatic wrist strap.
   d. Remove the top cover.

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
2. Remove the rear-mounted boot disk drive cage
   a. Loosen the two captive Phillips screws on the ends of the PCI crossbar.
   b. Grasp both ends of the PCI crossbar and pull it to the rear to disengage it from the chassis and then lift it up and out of the chassis.
   c. Disconnect the two SATA cables connectors from the rear of the boot disk drive cage.
   d. Disconnect the power cable from the rear of the boot disk drive cage.
   e. Remove the two green captive screws that secure the boot disk drive cage to the server chassis.
   f. Lift the cage up and out of the chassis.
3. Place the cage on an antistatic mat.
4. Install the rear-mounted boot disk drive cage
   a. Lower the boot disk drive cage into the server chassis
   b. Tighten the two green captive that secure the cage to the chassis
   c. Reconnect the boot disk drive cage power cable connector
   d. Reconnect the two SATA cable connectors to the disk drive cage
   e. Lower the PCI crossbar down into the chassis and then move it forward to engage the chassis and the rear-mounted components
   f. Tighten the two captive Phillips screws that secure the PCI crossbar to the chassis
5. Return the server to operation.
   a. Install the top cover.
   b. Return the server to the normal rack position.
   c. Reconnect the power cord(s) to the power supply (or supplies) and power on the server. Verify that the AC Present LED is lit.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:

PARTS NOTE:

REFERENCE INFORMATION

This solution has no attachment