How to remove and replace M4000 M5000 Air Filter:ATR:1156:2

Asset ID:	1-71-1310913.1
Update Date:	2016-01-20
Keywords:

Solution Type Technical Instruction Sure

Solution 1310913.1 : How to remove and replace M4000 M5000 Air Filter:ATR:1156:2

Applies to:

Sun SPARC Enterprise M5000 Server - Version: Not Applicable and later [Release: N/A and later ]
Sun SPARC Enterprise M4000 Server - Version: Not Applicable and later [Release: N/A and later]
Information in this document applies to any platform.

Goal

How to remove and replace M4000 M5000 Air Filter
********************************************************************************
To report errors or request improvements on this procedure,
please go to http://support.us.oracle.com and put a comment on Doc ID: 1310913.1
********************************************************************************

Solution

DISPATCH INSTRUCTIONS

WHAT SKILLS DOES THE ENGINEER NEED:(IS A SITE ENGINEER AVAILABLE?)
Engineer has to complete the OPL system training

TASK COMPLEXITY: 2

TIME ESTIMATE: 30 minutes

FIELD ENGINEER INSTRUCTIONS

PROBLEM OVERVIEW:
Air filter needs to be replaced

WHAT STATE SHOULD THE SYSTEM BE IN TO BE READY TO PERFORM THE RESOLUTION ACTIVITY? :

A data backup is not a pre-requisite but is a wise precaution.
The customer should conduct an orderly software system shutdown.

WHAT ACTION DOES THE ENGINEER NEED TO TAKE:
1. Power the Domains off
2. Grasp the top edge corners of the air filter and slowly pull the air filter away
and down from the front of the server
Note - Test fit the filter to the front bezel of the server to make sure you know where it
will attach to the server. Clean the surface of the front bezel where
the hook and loop tapes make contact. Make sure the bezel is clean and dry
before proceeding.
Installing the air filter.
3. Locate the protective strips on the back side of the filter and clean the bezel in
the same places as the tape.
4. Carefully remove the tape protective backing, leaving the hook and loop tape
still attached to the filter.
5. Carefully position the air filter to the front of the server, making sure not to
impede the removal of the hard disk drive or CD-RW/DVD-RW drive unit.
6. Press firmly at all places where the sticky tape comes in contact with the bezel.
The air filter is now installed.

The air filter is held in place on the front of the server with hook and loop tape. The
tape has a sticky backing to it and one set of tape strips is already attached to the
filters. The mating hook and loop tape is attached to the filters tape by the hooks and
loops. The sticky side of this tape still has it's protective tape covering the sticky
side.

7. Start the domains.

OBTAIN CUSTOMER ACCEPTANCE

WHAT ACTION DOES THE CUSTOMER NEED TO TAKE TO RETURN THE SYSTEM TO AN OPERATIONAL STATE:
Boot the system and start the application as per the sys admin procedure

PARTS NOTE:

REFERENCE INFORMATION:
Service Manual: http://download.oracle.com/docs/cd/E19855-01/index.html

Attachments

This solution has no attachment