Sun StorageTek SL8500 Modular Library System
 

PLA-Support>Sun Systems>TAPE>Tape Hardware>SN-TP: SL3000-8500 Library
 

Applies to:

Goal

SL8500 - Part Number for Complete Pulley Assembly on Z-Frame Elevator Module

Solution

Part number for complete pulley assembly on Z-frame elevator module.
This part is needed occasionally when the bearing wears out or becomes noisy.

Part numbers are as follows:
Refer to the picture attached to this solution for reference.

Should there be a problem with any part of the pulley, the whole pulley sub-assembly can be ordered via Field Logistics.

- The Right elevator pulley assembly is: PN 419804601
- Left elevator pulley assembly is:  PN 419804501

Refer to the Pulley Replacement Instructions attached to this issue for removal/replacement information.

In the unlikely event that the whole Z Frame elevator module needs to be replaced,
Refer to ...    SL8500 - Part Number for Z- Frame Elevator Assembly (Doc ID 1022271.1)
(Very big, expensive, engineering need to be engaged and only one or two replaced in the field)

Information concerning pulley assembly replacement:

Both belt tension settings are self adjusting, engineering originally did not want the field to deal with them but it was determined that the dis-assembly and assembly could be accomplished without too much challenge.

If there are problems getting the elevator pulleys via Field Logistics, Phil Garcia is keeping some available at his desk.

This solution has no attachment