Fujitsu SPARC M12-1
 
Fujitsu SPARC M12-2
 
Fujitsu SPARC M12-2S
 

PLA-Support>Sun Systems>Sun_Other>Sun Collections>SN-OTH: Sun PSH
 

In this Document

Purpose

Details

References

Applies to:

Purpose

Provide additional information for message ID: M12-upset_domain.post

Fujitsu fault code:

02000e01

Details

Type

Hardware Fault

   upset_domain.post

Severity

Major

Description

Upset due to the fact that the XSCF could not determine that POST is running correctly in a domain.

The situations under which this upset can be detected are as follows:

- fe-start-err: 02000e01 The XSCF software could not determine that POST started successfully;

Automated Response

If the event occurred during POST at domain startup, the domain is powered down, and no other action is taken.

In all these cases, the platform administrator should check for some sort of fault that could have caused this failure. The platform administrator should schedule a service action.

Impact

Nothing is deconfigured.

Indicted Hardware

For fe-start-err event, an LSB, which failed to start, is specified.

Suggested Action for System Administrator

The recommended service action for this event is to schedule replacement of the affected component(s) at the earliest possible convenience. Although the hardware may be functioning, it is not intended nor recommended that the faulted component(s) remain in the system for a prolonged period of time.

Refer to the following document for the latest procedures for displaying event content in preparation for submitting a service request and applying any post-repair actions that may be required.

PSH Procedural Article for Fujitsu M10 Diagnosis (Doc ID 1525156.1)

This solution has no attachment