Replacing a Failed HP6120XG Switch

Asset ID:	1-79-2128352.1
Update Date:	2018-03-30
Keywords:

Solution Type Predictive Self-Healing Sure

Solution 2128352.1 : Replacing a Failed HP6120XG Switch

Applies to:

Oracle Communications Diameter Signaling Router (DSR) - Version DSR 3.0 and later
Tekelec

Purpose

This document provides the procedures for replacing a failed HP6120XG switch in an HP c-Class Enclosure

Scope

Details

Detailed steps are provided in the attached document.

NOTES:

Please go through following notes in addition to the document attached:

If the netconfig switch initialization command gives output "no adapter found" check if PMAC has the oa_service added.

Here are the steps to add the OA_Service on the PMAC

sudo /usr/TKLC/plat/bin/netConfig --repo addService name=oa_service_en<enclosure#>
Service type? (tftp, ssh, conserver, oa) oa
Service host? <OA1_enX_ip_address>
Enter an option name <q to cancel>: user
Enter the value for user: root
Enter an option name <q to cancel>: password
Enter the value for password: <OA_password>
Verify password: <OA_password>
Enter an option name <q to cancel>: q
Add service for oa_service successful

The above can also be found in section 4.3 of the 7.0.1 Install doc:
https://docs.oracle.com/cd/E57516_01/docs.70/E57789_rev_02.pdf

If restoreConfiguration initial run fails and gives error "SCP not enabled":
Run the following on the switch being replaced:

switch# config
switch(config)# ip ssh filetransfer
switch(config)# exit
switch#

This will allow the restore to complete successfully and the backup to be completed successfully as well.
In switch firmware Z.14.51 the AddQOS command via netconfig is not needed.

Attachments

This solution has no attachment