| Asset ID: |
1-72-2400660.1 |
| Update Date: | 2018-05-24 |
| Keywords: | |
Solution Type
Problem Resolution Sure
Solution
2400660.1
:
IBM LTO7 - DRIVE SHOWS "ERROR IMAGE IS NOT VALID" AS STATUS OF THE INTERFACE INSTEAD OF 4GB
| Related Categories |
- PLA-Support>Sun Systems>TAPE>Tape Hardware>SN-TP: OEM Drive and Library
|
In this Document
Created from <SR 3-17463747996>
Applies to:
IBM LTO7 Tape Drive - Version All Versions and later
Information in this document applies to any platform.
Symptoms
Customer set drives to ADI and this drive did not load ADI setting; report getting the following message: DRIVE SHOWS "ERROR IMAGE IS NOT VALID" AS STATUS OF THE INTERFACE INSTEAD OF 4GB
Changes
Cause
Drive was not properly re-enrolled after changing to ADI mode.
Solution
After setting drive to ADI mode, it must be un-enrolled and then re-enrolled to activate ADI on the drive.
Check Oracle Key Manager (OKM) - Upgrade of LTO7 Belisarius Card to 5.32.20.40 Causes Encryption Issues in OKM Versions Below 3.1 (Doc ID 2303290.1)
References
<NOTE:2303290.1> - Oracle Key Manager (OKM) - Upgrade of LTO7 Belisarius Card to 5.32.20.40 Causes Encryption Issues in OKM Versions Below 3.1
Attachments
This solution has no attachment
