SPARC T4-1
 
SPARC T4-2
 
SPARC T4-4
 

PLA-Support>Sun Systems>SPARC>CMT>SN-SPARC: T4
 

In this Document

Symptoms

Changes

Cause

Solution

Created from <SR 3-9354470001>

Applies to:

Symptoms

 {0} ok setenv auto-boot? false
WARNING: Error storing configuration variable. No space left, check SP and other logs
        Configuration variable setting will not persist after a reset or power cycle
auto-boot? =  false
{0} ok

=========

the ilom not setting the "script" property.

-> cd /HOST/bootmode
/HOST/bootmode

-> show

/HOST/bootmode
   Targets:

   Properties:
       config = factory-default
       expires = (none)
       script = (none)
       state = normal



-> set script="setenv auto-boot? false"
Set 'script' to 'setenv auto-boot? false'

-> show

/HOST/bootmode
   Targets:

   Properties:
       config = factory-default
       expires = (none)
       script = (none)
       state = normal

Changes

 None

Cause

This could be due to corruption in ILOM firmware.

Please verify the same as below:

1) In snapshot data, check spos_info directory, for '@bin@df_-k.out' to see usage of /coredump

/dev/mtdblock6           12288      1808     10480  15% /coredump
## The SP filesystem was not full.

2) In snasphot data, event logs check if they tried fw upgrade.

704    Wed Jul 16 07:58:32 2014  Power     On        major  
      Power to /SYS has been turned on by: SP, Reason: Firmware update complete
700    Wed Jul 16 07:54:52 2014  Power     Reset     major  
      /SP has been reset by: SP, Reason: Firmware update complete
691    Wed Jul 16 07:49:42 2014  Power     Off       major  
      Power to /SYS has been turned off by: SP, Reason: Firmware update failed
## The firmware was upgraded on the system.

Solution

1) Reflash the ilom firmware with saving the configuration.
2) Check if it works, else re-flash firmware without saving the current configuration. i.e.

--> Back up ilom configuration using 'set dump_uri=ftp://<user>:<password>@hostIP/tmp/file.config'
--> Try re-flashing the System Firmware without saving the current configuration (Please don't select the preserve the settings)
--> Check if it works, then restore the configuration by 'set load_uri=ftp://<user>:<password>@hostIP/tmp/file.config', else next step.
--> Set System to factory defaults using 'set /SP reset_to_defaults=factory'.
--> Check if it works, then restore the configuration by 'set load_uri=ftp://<user>:<password>@hostIP/tmp/file.config', else next step.
--> Log a Service Request with Oracle Support to resolve this issue.

 The SP was replaced and the issue got fixed

This solution has no attachment