SL150 - Library Will Not Initialize, FSC9141 and FSC9142

Asset ID:	1-72-1917803.1
Update Date:	2017-05-05
Keywords:

Solution Type Problem Resolution Sure

Solution 1917803.1 : SL150 - Library Will Not Initialize, FSC9141 and FSC9142

Applies to:

StorageTek SL150 Modular Tape Library - Version All Versions and later
Information in this document applies to any platform.

This is a new install of the SL150.
There are a total of 7 modules installed.

Symptoms

Library will not initialize.

9141 Robot Z Locate Sensor Always off Expansion Module 2

9142 Robot Z Locate Sensor Always on Expansion Module 2

Changes

New installation of library.

Cause

There was a defective sensor in the expansion module.

Solution

Replaced defective expansion module to resolve issue.

7021882 [C] Expansion Module Chassis

SL150 - How To Remove/Replace an Expansion Module Chassis CRU in the StorageTek SL150 Modular Tape Library:ATR:1473453.1:0 (Doc ID 1473453.1)

Note: There was a documentation issue in older FSC information. This is being resolved in 2.50 firmware due out in Dec. 2014. Refer to the following knowledge entry for further details.

SL150 - Incorrect Remedy or Suggested Action Information in User's Guide (Doc ID 1917764.1)

Note: The Z sensor is not the same as the magazine sensor.

References

<NOTE:1532413.1> - SL150 - Initialization Failure, Robot Z Home Sensor Initialization Error, Fault Code 9135

Attachments

This solution has no attachment