SL8500 - Fire Suppression Information Dimension Errors in SAG (Systems Assurance Guide)

Asset ID:	1-72-1550542.1
Update Date:	2017-09-07
Keywords:

Solution Type Problem Resolution Sure

Solution 1550542.1 : SL8500 - Fire Suppression Information Dimension Errors in SAG (Systems Assurance Guide)

Applies to:

Sun StorageTek SL8500 Modular Library System - Version All Versions and later
Information in this document applies to any platform.

Symptoms

Fire Suppression Information Dimension Errors in SAG (Systems Assurance Guide).

Cause

Error in the SAG documentation.

Solution

In the past I mentioned that the fire suppression information in the SL8500 System Assurance Guide had a dimensional error. In the current version of the SAG, E24254-08, the issue can be found on page 6-17. It was also found that a second bullet in that same section also contains an error. Both issues are scheduled to be corrected in the next SAG release.

The clearance information located under the last bullet for "Nozzle Protrusion" is wrong. The measurement is "2.54 cm (1 in.)" NOT "1 cm (0.4 in.)"
The second bullet "Plates" should have the thickness as "1.2 mm (.048in.)" NOT "1 cm (.48 in.)"

Screenshot from Figure 6-12 in SAG:

The following list describes the key fire supression features:

Openings - 2 per module that measure 5 cm (2 in.) diameter.

Plates - These cover the openings and measure 7 cm (2.75 in.) square and 1 cm (0.48 in.) thick. The contractors can use these plates to drill in to for a customer fit of the nozzles.

Screws - 2 T25 Torx screws.

Nozzle protrusion (clearance) - 1 cm (0.4 in.) from the top of the library for robotic operation.

Attachments

This solution has no attachment