Sun Microsystems, Inc.   Oracle System Handbook - ISO 7.0 May 2018 Internal/Partner Edition
   Home | Current Systems | Former STK Products | EOL Systems | Components | General Info | Search | Feedback

Netra[tm] T1 AC200 / DC200 Servers: Repair Procedures

This section provides the most common repair procedures for the Netra T1 AC200/DC200, which are included in the following manual:

Netra T1 AC200 and DC200 Server User's Guide (806-5978)

The following table provides the page numbers for each procedure.

Component Tips
CD-ROM Drive
Disk Drive
  • Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (FIN I1136-1).
  • When inserting a hard disk drive into its enclosure, make sure the top of the disk drive is touching the top of the enclosure. If you try to install it with the bottom of the disk drive touching the bottom of the enclosure, the drive will not align with the slide rails inside the encloser, and you will not be able to insert the drive. (Product Notes, 806-6134)
  • 18.2GB and 36GB IBM disk drives may be susceptible to early life failures problem (FIN I0724-2).
  • Systems with 18.2GB and 36GB IBM disk drives may experience higher than expected failure rate. (FCO A0182-2).
Netra T1 AC200 (entire system)
  • This procedure provides instructions to replace an entire system, because you can re-use an old server's MAC address, serial number, and NVRAM settings into the new system.
NVRAM

  Copyright © 2018 Oracle and/or its affiliates.  All rights reserved.
 Feedback