| Processor |
| Number |
Two Intel 8-core |
| Architecture |
8-Core Intel Xeon E5-2658 (20MB Cache, 8 GT/s QPI, 2.1 GHz, 95W) |
| Cache memory |
32KB instruction and 32KB data L1 cache per core
256KB unified (data and instruction) L2 cache per core
20MB shared inclusive L3 cache per processor |
| Main Memory |
| Capacities |
DIMM slots per CPU socket: 8
Total DIMM slots: 16
DIMM type: DDR3-1600 Registered DIMMs
DIMM size: 8GB / 16GB
Capacities:
ECB:8GB DIMMs min = 2 / max = 2
16GB Dimms min = 2 / max = 2
ASC:8GB DIMMs min = 4 / max = 4
16GB Dimms min = 2 / max = 2
SR:8GB DIMM min = 2 / max = 8
16GB Dimms min = 1 / max 4
|
ECB: Enterprise Communication Broker
ASC: Application Session Controller
SR: Session Router |
| Standard Integrated Interfaces
|
| Network |
Four 100 Mb/s, 1000 Mb/sec, 10000 Mb/sec Ethernet ports |
| Network Management |
One 10/100Base-T Ethernet port |
| Serial Management |
One TIA/EIA-232-F asynchronous RJ45 port |
| SAS |
Four-channel SAS Interface (with SFF-8088 connector), internal access
only |
USB (2.0)
|
Front: 2
Rear: 2
Internal: 2
|
Video
|
One VGA Video port (HD-15)
|
Alarms
|
Four fail-safe DB-15 dry contact
(critical, major, minor and user)
|
| Expansion Bus |
Six PCIe 3.0 LP slots - six (6) x8-lane slots
Note: Slot 1, the lower slot of Riser 1 is reserved for the Sun Storage
6 Gb SAS PCIe HBA, Internal card. This is a configuration requirement.
|
| Internal Mass Storage |
Disk
|
ECB:300GB disk min = 1 / max = 2
ASC:300GB disk min = 2 / max = 6
SR:300GB disk min = 1 / max = 2
|
ECB: Enterprise Communication Broker
ASC: Application Session Controller
SR: Session Router |
| Power Supplies |
Two 660W (1+1) hot-swappable
DC or Two 760W hot-swappable AC
Note: To ensure redundant operation of
the power supplies, the two power inputs should be connected to separate
power sources.
|
DC Power
|
-48V DC or -60V DC
|
AC Power
|
100-240V AC, 50-60 Hz
|
| Environment |
| Temperature |
Operating: 5° C to 45° C (41° F to 113° F)/Short
term: 5° C to 55° C (23° F to 131° F)
Nonoperating: -40° C to 70° C (-40° F to 158° F)
|
| Humidity |
Operating: 5% to 85% relative humidity noncondensing, max wet bulb.
Short term: 5% to 90% relative humidity noncondensing, but not to exceed
0.024kg water/kg dry air (0.053 lbs. water 2.205 lb. dry air)
Nonoperating: up to 93% relative humidity noncondensing, 40°
C (104° F) max wet bulb
|
| Altitude |
Operating: Meets NEBS 4,000m (13,123 ft.)
Nonoperating: up to 12,000m (39,370 ft.) |
| Acoustic noise |
Operating/Idling Acoustic Noise less than 7.2B @ 25° C (LwAd, 1B=10dB) |
Regulations
Meets or exceeds the following requirements: |
| Safety |
UL 60950-1, EN60950-1, IEC60950-1 (Evaluated to all CB countries), CSA
C22.2 No. 60950-1-07, IEC825-1, 2, and CFR21 part 1040 |
| NEBS |
NEBS Level 3 certified by Telcordia |
| EMI |
EN55022 Class A, CISPR22 Class A, 47 CFR 15B Class A, ICES-003 Class
A, VCCI Class A, AS/NZ CISPR22 Class A, CNS 13438 Class A, EN300386 for
Telecommunications Centers and for Other Than Telecommunications Centers
|
| EMC (immunity) |
EN55024, EN61000-3-2, EN61000-3-3, EN300386:2010 for Telecommunications
Centers and for Other Than Telecommunications Centers. |
Regulatory Markings
|
CE, FCC, ICES-003, C-tick, VCCI, GOST-R,
BSMI, KCC, UL/cUL, S-mark, CCC
|
Seismic
|
GR-63-CORE requirements for earthquake zone
4
|
Other
|
Restriction of Hazardous Substances (RoHS)
Directive and Waste Electrical and Electronics Equipment (WEEE) Directive
|
| Dimensions and Weight |
| Height |
87 mm (3.43 in.) 2 RU
|
| Width |
445 mm (17.52 in.) including mounting ears |
| Depth |
maximum to PSU handles: 527.8 mm (20.78 in.)
maximum of rear I/O: 501.4 mm (19.74 in.)
|
| Weight |
Approximate (without PCI cards)
18.5 kg (40.8 lb.)
|
| Rack Mounting |
Rack Units
|
2
|
| Rack Kits Available |
- 19-inch 2-post
- 19-inch 2-post (slide rail)
- 23-inch 2-post
- 600mm x 600mm and
- 19-inch 4-post slide adjustable1
|
1 The slide kit includes hardware that enables
mounting to any of the following types of rack rails:
- 6 mm threaded holes
- #10-32 threaded holes
- #10 threaded holes
These must be compliant racks which have mounting depths of 27-30 inches.
|
