|
|
| Chassis |
- 1U, rackmount
- Front: Display, console, and local storage interfaces
- Rear: One NIU slot (signaling, media, and management interfaces)
- Optional mounting brackets for front, rear, or center mount in a 19 inch or 23 inch rack
|
| Memory |
- 4GB for configuration files and Net-Net OS software storage
- 256MB internal flash memory
|
| Content Addressable Memory (CAM) |
- 256K entries for static and dynamic access control lists (ACLs), media control rules,
and Address Resolution Protocol (ARP) entries
|
| Local Storage |
- Optional 500GB storage expansion module for call detail record (CDR) backup
|
| Secure Services Module (SSM) |
- Hardware acceleration option for TLS, IPsec session establishment with use of nonmanual keys
- Standard for multiservice security gateway (MSG) configurations
- Optional for SBC configurations, required for TLS, required for IPsec with use of nonmanual keys
|
| Front Panel Management Interfaces |
- One RS-232 serial console interface with RJ-45 connector (only rear or front interface may be used at any time)
- One USB 2.0 interface
- One system status display with keypad
|
Network Interface Units (NIU) |
| Basic Interface Unit |
- Four 10/100/1000 Mbps Ethernet copper ports (RJ-45 connector)
- Four 1000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Four 10000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports with inline IPsec/SRTP encryption
processors (requires SFP transceivers)
- Four 10000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports with inline QoS measurement
processors (requires SFP transceivers)
- Four 10000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports with inline IPsec/SRTP encryption
and QoS measurement processors (requires SFP transceivers)
|
| Transcoding Interface Unit |
- Four 1000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Up to twelve on-board transcoding digital signal processor (DSP) modules
- Inline QoS measurement processors
|
| Enhanced Traffic Control Interface Unit |
- Four 1000 Mbps Ethernet fibre or four 10/100/1000 Mbps copper ports (requires SFP transceivers)
- Integrated high-capacity encryption (IPsec, SRTP, TLS) processors
- Inline QoS measurement
- Integrated hardware-based SIP-TLS and TCP processing
|
| 10 Gbps Enhanced Traffic Control NIU |
- Two 10 Gbps Ethernet fibre ports (requires SFP+ transceivers)
- Integrated high-capacity encryption (IPsec, SRTP, TLS) processors
- Inline QoS measurement
- Integrated hardware-based SIP-TLS and TCP processing
|
| Network Interface Unit Management Interfaces - included on all NIU options |
- Two 10/100/1000 Mbps interfaces with RJ-45 for HA node configurations
- One 10/100/1000 Mbps interface with IPsec encryption processor and RJ-45 for management networks
(Optional IPsec encryption of management interface via encryption capable NIU)
- One RS-232 serial console interface with RJ-45 connector (only rear or front interface may be used
at any time)
|
|
|
| AC Power |
- Voltage: Autoranging 100 AC to 240 AC wide input with power factor correction
- Frequency: 50/60 Hz
- Current: 3A × 2 rating
- Cable: 2.0m 18 AWG three-wire cable, with three-lead IEC 320 receptacle on the power supply
end and a country-dependent plug on the power source end
|
| -48 DC Power |
- Voltage: -48 DC (+/− 10%) nominal in North America (maximum range: -40 DC to -60 DC)
- Current: 7A × 2 rating
- Cable: 18 AWG recommended minimum, with at least three conductors rated for at least 60° C (140° F)
|
| -72 DC Power |
- Voltage: -72 DC nominal in Russia
- Cable: 18 AWG recommended minimum, with at least three conductors rated for at least 60° C (140° F)
|
| Temperature |
Operating: +0° C to +40° C (32° F to 104 ° F)
Nonoperating: -20° C to 65° C (-4° F to 149° F) |
| Relative Humidity |
Operating: 10% to 85% (non-condensing) |
| Air Flow |
50 CFM front to back |
| Heat Dissipation |
Typical: 100W (341 BTU/hr)
Maximum: 200W (682 BTU/hr) |
| Power Dissipation |
Typical: 100W
Maximum: 200W |
|
|
| Height |
4.37 cm (1.72 in) |
| Width |
43.18 cm (17.00 in) |
| Depth |
48.26 cm (19 in) |
| Weight (maximum) |
8.62 kg (19 lb), fully loaded |
|
|
| Overall |
European Compliance (CE) marking indicating compliance with the
99/5/EC directive which includes the following European Norm (EN)
and IEC standards for safety and electromagnetic compatibility |
| Safety |
US: UL 60950-1 Second Edition
Canada: CSA-C22.2 No. 60950-1-07, Second Edition
C22.2 No. 60950-1-03, First Edition
EU: EN 60950-1:20012006 |
| Electromagnetic Compatibility (EMC) |
US: FCC Part 15 (CFR 47), Class A Limits
Canada: ICES-003 Issue 4, Class A Limits
EU: EN 55022:2006 + A1:2007 Class A Limits
Germany: 1 TR 9
Japan: VCCI Class A Limits |
| Immunity |
EU: EN 300 386 v1.4.1 |
| NEBS |
GR-63
GR-1089
SR-3580: Level 3 Certified |
| US Department of Defense Security |
FIPS 140-2 Compliant
DISA Unified Communication Requirements (UCR) Compliant
Listed: DISA Unified Capabilities Approved Product List (UCAPL) |
|
|
| Front or center mounted in 19" wide racks (up to 28" deep) with options for 23" wide racks. |
Clearance
and Service Access
|
| Front |
20 cm (8 in) |
| Rear |
10 cm (4 in) |
Leave enough clearance, approximately 20 cm (8 in), in front of the equipment rack
to allow access to the console connector, reset button, graphic display buttons,
and physical interface card slots. |
Leave enough clearance, approximately 10 cm (4 in), in the rear of the equipment rack
to allow for sufficient airflow and for ease in cabling and/or servicing the rear panel. |
