Sun StorEdge[tm] 6020/6120 Array: Repair Procedures

This section provides the most common repair procedures for the 6020/6120. The repair procedures are provided in the following manual:

Sun StorEdge 6020 and 6120 Arrays System Manual

The table below provides the section and page number that each procedure begins on.

Component	Tips
Array Controller	Minimum supported releases for the Sun StorageTek T3+, 6120, 6320 and 6920. (FAB 1000787.1).
Controller Card	Sun StorEdge 6120 Arrays and 6320 Systems may reset due to a Controller Board SRAM timing issue (FIN I1043-2).
Disk Drives	Improved firmware for Seagate 10K.6 disk drives will reduce the incidence of unexpected outages due to a spindle motor issue (FIN I1136-1). During power on (cold boot), one or more drives may come up in an offline state (FIN I1009-2) Seagate Cheetah 7 146GB FC-AL and 73 GB FC-AL disk drives may experience higher than expected failure rates due to spindle motor failure (FCO A0256-1). Seagate Cheetah 7 FC-AL and SCSI disk drives with serial numbers below 60000 are experiencing a higher than expected failure rate due to a spindle motor issue (FCO A0239-1).
Power Supply	StorageTek 6140 Family contains incorrect UL power supply label (FAB 1019519.1).
Power and Cooling Units	StorEdge 6020/6120 Arrays may automatically power themselves up after being placed in standby mode (FIN I1002-1).
SAN Multiplatform Support	This site, Sun Storage Networking provides information as follows: Multi-Platform Support Documents Get the Software